Pictures & video

To see more than 200 screenshots from Motovator, please download the user guide...

Video

Motovator Demo Video

Real-life demo video showing how to start a session, set splits and receive feedback on track...

Low speed connection 		Motovator Demo Video
Motovator Mounting on TM Video

Learn how to mount Motovator on a TM 450F...

Low speed connection 		Motovator Mounting on TM Video

Pictures

Motovator Mounting Guide
This is a step by step guide on fitting RAM mounts, Otterbox and PocketPC on a KTM 250 SXF 2007. Use this guide as inspiration for mounting Motovator on your own bike.

You can also download this guide in PDF-format...
  Remove the barpad
  Place the handlebar mount midway between clamps, with ball pointing towards seat, and tighten nuts
  Mark bolts app. 10 mm out, dismount and cut bolts
  Remount and add plastic caps to bolt ends
  Press handlebar pad as far down as possible and mark where to cut foam
  Cut foam, remount handlebar pad and test for fit. Continue to cut foam until it sits correctly.
  Foam fits...
  Plastic cover might also need one or more alterations...
  Place mount inside Otterbox and mark where to drill holes
  Drill holes for bolts
  Insert washer and bolt into holes
  Add mount to back of Otterbox and tighten nuts
  Use connector to attach Otterbox to handlebar mount. Do not tighten connector yet...
  Position Otterbox to your preference
  Tighten connector
  Insert one or more foam plates in bottom of Otterbox, so the PocketPC will be protected from bolts and kept in place
  Make sure the PocketPC is centred and none of the buttons are pressed by the Otterbox
  Close the lid - gently! It should keep the PocketPC in place - but not squeeze the guts out of it...
  Done! Start Motovator...
  View of Motovator mounted - from side
  View of Motovator mounted - from driver perspective